Panel to measure and adjust the value of pH, the concentration of Free chlorine and temperature.

Includes:

- Instrument for Measuring free chlorine and pH PC95.
- Probe to amperometric Chlorine Free (Pt-Cu) clean (Pt - Cu).
- Probe measuring pH.
- Self control and the efficiency of the probe (pH).
- Washable filter, buffer solutions and DPD kit.
- Installation kit included.

Series Panel KONTROL
- Self for all measures
- Sensor with Portasondas flow regulating valve and flow control.
- Alarm signal for lack of flow.
- Instrument with IP65 degree of protection.
- 2 relays Connection (5A - 250 Va).
- Departures 4 .. 20 mA for transmission of each of the measured parameters, the possibility of imposing the range.
- Food: 230 Vac (standard) or 155 Vac (upon request).
- Set point and configurable alarm for each parameter.
- Bombs in pause mode during calibration
- Compensation Cloro with the reading of the temperature, with probe PT100, and the pH

Technical Data:

Instrument PC95:
ACTION: 240 mm - 245 mm - 140 mm.
DEGREE OF PROTECTION: IP65.
SECTION of the terminals: 4mm2, or 2.4 mm diameter.
FOOD: standard 230V ± 10% 50-60 Hz, on request 115V.
CONSUMPTION: 15W.
RELAY: 2 (One for each parameter).
MAXIMUM CAPACITY IN RELAY: 3A 250VAC (with resistive load).
TEMPERATURE OF WORK 0 ... 50 ° C.
Storage temperature -10 ... +70 ° C.
SCALE OF MEASURE OF pH: 0 ... 14.00 pH.
Input impedance:> 1013 ohm.
COMPENSATION IN TEMPERATURE: manual / automatic 0 ... 125 ° C.
SETTING THE SET POINT: ON / OFF-BREAK / WORK - IN CURRENT PROPORTIONAL.
Relay OUT: 0 / 4 ... 20 mA galvanically separated Fully configurable for retransmission measurement or regulation, Resolution 255 points, 1 K ohm load.
SCALE OF MEASURE Cl: 0 ... 5.00 ppm or mg / l.
COMPENSATION WITH TEMPERATURE: manual / automatic 0 ... 125 ° C.
COMPENSATION IN pH range of compensation 6 ... 8.35 pH.
SETTING THE SET POINT: ON / OFF - PAUSE / WORK - PROPORTIONAL.